How to use high fidelity system in a sentence? Find typical usage patterns (collocations)/phrases/context for "high fidelity system" and check conjugation/comparative form for "high fidelity system". Mastering all the usages of "high fidelity system" from sentence examples published by news publications.
Sound chip ES1938 ES1868 AudioDrive ES9218P SABRE high fidelity system-on-chip; 32-bit stereo mobile digital-to- analog converter with 2 Volt headphone amplifier.
|
|
Deep feedback inevitably causes sudden, harsh onset of distortion at overload but Williamson was content with this flaw. He argued that it is a price worth paying for an improvement in linearity at medium and high power levels. On the contrary, wrote Williamson, slow but steady rise of distortion to 3–5%, as advocated by Kellogg, is distinctly unwanted in a high fidelity system.
|
|
ERAM also provides a user- friendly interface with customizable displays. It revolutionizes controller training with a realistic, high-fidelity system that challenges developmental practices with complex approaches, maneuvers, and simulated pilot scenarios that are unavailable with Host. In 2016, the Terminal Automation Modernization and Replacement program's Standard Terminal Automation Replacement System (STARS) was deployed at the largest 11 terminal radar approach control (TRACON) facilities. These facilities handle 80 percent of all traffic arriving and departing from U.S. airports with state-of-the-art technology and equipment.
|
|
Still later, phase locked loop methods were used, with microprocessor control. In a self-contained radio receiver for audio, the signal from the detector after the tuner is run through a volume control and to an amplifier stage. The amplifier feeds either an internal speaker or headphones. In a tuner component of an audio system (for example, a home high-fidelity system or a public address system in a building), the output of the detector is connected to a separate external system of amplifiers and speakers.
|
|
In 1952, Emory Cook (1913–2002), who already had become famous by designing new feedback disk-cutter heads to improve sound from tape to vinyl, took the two- channel high-fidelity system described above and developed a somewhat misnamed "binaural" record out of it, which consisted of the same two separate channels cut into two separate groups of grooves running next to each other as described above, i.e. one running from the edge of the disc to halfway through and the other starting at the halfway point and ending up towards the label, but he used two lateral grooves with a 500 Hz crossover in the inner track to try and compensate for the lower fidelity and high frequency distortion on the inner track. Each groove needed its own monophonic needle and cartridge on its own branch of tonearm, and each needle was connected to a separate amplifier and speaker. This setup was intended to give a demonstration at a New York audio fair of Cook's cutter heads rather than to sell the record; but soon afterward, the demand for such recordings and the equipment to play it grew, and Cook Records began to produce such records commercially.
|
|
No results under this filter, show 5 sentences.